CAUTION: Light bulbs become extremely hot when turned on.

DO NOT touch the bulb until switched off and cooled. Touching hot bulbs could cause serious burns.

Make sure all power is turned off from the circuit breaker and bulbs are not hot. 

Please find the light bulb that matches your hood. You can purchase replacement bulbs at our Parts and Accessories Store

Consult your owner's manual for specific part numbers.

LumaLight LED

1. Remove filters.

2. Disconnect LED light quick connector.

3. Push in the two side clips on the ends of the LED light.

4. Push LED light through the light panel opening.

LED Light Strips

1. Remove aluminum mesh filters.

2. Remove light panel by two screws.

3. Disconnect LED light strip quick connector.

4. Push in the two side clips on the ends of the LED strip.

5. Push LED light strip through the light panel opening.

Bloom

1. Remove aluminum mesh filters.

2. Remove light panel by two screws.

3. Disconnect Bloom LED light quick connector.

4. Remove two screws from each side of Bloom LED

5. Push Bloom LED light through the light panel opening.

GU10

Remove by turning bulb counter clockwise. Note: Bulb does not unscrew; it turns 60 degrees, stops and falls out.

If bulbs are difficult to turn due to prolonged use, firmly attach suction cup included in hardware package or use a rubber/latex glove and turn counter clockwise.